Embedded Tester Protocol (ETP) library for Python

etplib allows access to microcontroller peripherals from a host computer. Microcontroller should be running the ETP firmware.

Inital setup

• Install etplib using pip terminal pip install etplib

Flashing ETP firmware

Arduino Uno

• Download ETP firmware for Arduino Uno
• Flash ETP firmware to the Arduino Uno using avrdude (Get avrdude here)

terminal avrdude -v -p atmega328p -c arduino -P COM4 -b 115200 -D -U flash:w:etp_fw_arduino_uno_v0.1.0.hex:i

NOTE : Replace COM4 with the port where the Arduino Uno is connected

ESP32

• Download ETP firmware package for ESP32
• Install esptool using pip terminal pip install esptool
• Run flash.bat (Windows) or flash.sh (Linux) to flash the ETP firmware to the ESP32

  NOTE : ETP firmware for ESP32 is experimental !

Usage

Blink LED

import etplib
import time

etp = etplib.ETP(transport='serial', port='COM4', baudrate=115200)
etp.open()
etp.reset()

etp.gpio.init({"_13": "output"})

# Blink LED on pin 13 of the Arduino Uno
while True:
    etp.gpio_write({"_13": 1})
    time.sleep(1)
    etp.gpio_write({"_13": 0})
    time.sleep(1)

etp.close()